COMBUSTION TYPE POWER HEATER SYSTEM, Diagnostic DTC:052

DTC Code DTC Name
052 Safety Time Exceeded

DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area
052 Safety Time Exceeded A heater ignition failure is detected.
  • Exhaust air duct

  • Intake air duct

  • Fuel pump filter

  • Heater pump assembly

  • Heater assembly

PROCEDURE


  1. INSPECT INTAKE AIR DUCT


    1. Inspect the intake air duct.

      Result
      Result Proceed to
      There is no problem with the intake air duct A
      The intake air duct is clogged, or other problems are found B

    B
    A
  2. INSPECT EXHAUST AIR DUCT


    1. Inspect the exhaust air duct.

      Result
      Result Proceed to
      There is no problem with the exhaust air duct A
      The exhaust air duct is clogged, or other problems are found B

    B
    A
  3. INSPECT HEATER PUMP ASSEMBLY


    1. A01QPMMN01

      Remove the heater pump assembly.

      Click here

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 (B2) - 2 (E2) Always 9 to 12 Ω
    3. Inspect heater pump assembly operation.


      1. Connect a positive (+) lead from the battery to terminal 1 (B2) and a negative (-) lead to terminal 2 (E2), and check the pressure of the hose by hand.

        Note

        This inspection must be done quickly (within 10 seconds) to prevent damage to the heater pump assembly.

        OK
        The pressure is applied to the hose.
      Result
      Proceed to
      OK
      NG

    NG
    OK
  4. CHECK FUEL PUMP FILTER


    1. Replace the fuel pump filter with a new one and check that the condition returns to normal.

      OK
      The heater is ignited normally and starts operating.
      Result
      Proceed to
      OK
      NG

    OK
    NG