AIR CONDITIONING SYSTEM(for Manual Air Conditioning System) PRECAUTION


  1. IGNITION SWITCH EXPRESSIONS


    1. The type of ignition switch used on this model differs according to the specifications of the vehicles. The expressions listed in the table below are used in this section.

      Expression Ignition Switch (Position) Engine Switch (Condition)
      Ignition Switch off LOCK Off
      Ignition Switch ACC ACC On (ACC)
      Ignition Switch ON ON On (IG)
      Engine Start START On (Start)

  2. ALWAYS WEAR EYE PROTECTION

  3. BE CAREFUL NOT TO GET LIQUID REFRIGERANT IN EYES OR ON SKIN

    A00YTU6

    If liquid refrigerant gets in eyes or on skin:


    1. Wash the area with lots of cold water.

      CAUTION:

      Do not rub eyes or skin.

    2. Apply clean petroleum jelly to the skin.

    3. Go immediately to a hospital or see a physician for professional treatment.

  4. NEVER HEAT CONTAINER OR EXPOSE THE CONTAINER TO AN OPEN FLAME

  5. BE CAREFUL NOT TO DROP CONTAINER OR APPLY PHYSICAL SHOCKS TO IT

  6. DO NOT OPERATE COMPRESSOR WITHOUT ENOUGH REFRIGERANT IN REFRIGERANT SYSTEM

    If there is not enough refrigerant in the air conditioning system, oil lubrication will be insufficient and the compressor may be damaged.

    Necessary care should be taken to avoid this.

  7. DO NOT OPEN HIGH PRESSURE MANIFOLD VALVE WHILE COMPRESSOR IS OPERATING

    A00YSCZC13
    *a Wrong
    *b Okay

    1. Open and close only the low pressure valve.

      If the high pressure valve is opened, refrigerant flows in the reverse direction causing the charging cylinder to rupture.

  8. BE CAREFUL NOT TO OVERCHARGE SYSTEM WITH REFRIGERANT

    If the system is overcharged with refrigerant, it causes problems such as insufficient cooling, poor fuel economy, engine overheating, etc.

  9. DO NOT OPERATE ENGINE AND COMPRESSOR WITH NO REFRIGERANT

    CAUTION:

    Doing so may damage inside the compressor because the compressor parts always move regardless of whether the air conditioning system is turned on or off.

  10. GENERAL PRECAUTION


    1. While using the battery during inspection, do not bring the positive (+) and negative (-) tester probes too close to each other as a short circuit may occur.