REAR SEAT INNER BELT ASSEMBLY INSPECTION

PROCEDURE

1. INSPECT REAR SEAT INNER BELT ASSEMBLY LH

   
   
   1. 

      *a	Component without harness connected (Rear Seat Inner Belt Assembly LH)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition 1 - 2 Rear LH seat belt not fastened Below 1 Ω 1 - 2 Rear LH seat belt fastened 10 kΩ or higher

      If the result is not as specified, replace the rear seat inner belt assembly LH.

2. INSPECT REAR SEAT INNER BELT ASSEMBLY RH

   
   
   1. 

      *a	Component without harness connected (Rear Seat Inner Belt Assembly RH)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition 1 - 2 Rear RH seat belt not fastened Below 1 Ω 1 - 2 Rear RH seat belt fastened 10 kΩ or higher

      If the result is not as specified, replace the rear seat inner belt assembly RH.

3. INSPECT REAR CENTER SEAT LAP TYPE BELT ASSEMBLY RH

   
   
   1. 

      *a	Component without harness connected (Rear Center Seat Lap Type Belt Assembly RH)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition 1 - 2 Rear center seat belt not fastened Below 1 Ω 1 - 2 Rear center seat belt fastened 10 kΩ or higher

      If the result is not as specified, replace the rear center seat lap type belt assembly RH.