FRONT SEAT INNER BELT ASSEMBLY INSPECTION

PROCEDURE


  1. INSPECT FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)


    1. A00YWLHC01
      *a

      Component without harness connected

      (Front Seat Inner Belt Assembly (for Driver Side))

      w/o Seat Position Airbag Sensor:

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      2 - 3 Driver seat belt unfastened Below 1 Ω
      2 - 3 Driver seat belt fastened 10 kΩ or higher

      If the result is not as specified, replace the front seat inner belt assembly (for Driver Side).

    2. A00YRA7C01
      *1 Connector A
      *2 Connector B
      *a

      Component without harness connected

      (Front Seat Inner Belt Assembly (for Driver Side))

      w/ Seat Position Airbag Sensor:

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A-3 (LSP-) - B-1 Always Below 1 Ω
      A-4 (LSP+) - B-2 Always Below 1 Ω

      If the result is not as specified, replace the front seat inner belt assembly (for Driver Side).

  2. INSPECT FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)


    1. A00YWHCC03
      *1 Connector A
      *2 Connector B
      *a

      Component without harness connected

      (Front Seat Inner Belt Assembly (for Front Passenger Side))

      w/o Occupant Detection ECU:

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A-3 (+) - B-1 Always Below 1 Ω
      A-2 (E)- B-3 Front passenger seat belt unfastened Below 1 Ω
      A-2 (E) - B-3 Front passenger seat belt fastened 10 kΩ or higher

      If the result is not as specified, replace the front seat inner belt assembly (for Front Passenger Side).

    2. A00YVGMC01
      *1 Limit Switch
      *a

      Component without harness connected

      (Front Seat Inner Belt Assembly (for Front Passenger Side))

      w/ Occupant Detection ECU:

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 (LSP-) - 4 (LSP+) Limit switch pushed Below 1 Ω
      3 (LSP-) - 4 (LSP+) Limit switch not pushed 10 kΩ or higher

      If the result is not as specified, replace the front seat inner belt assembly (for Front Passenger Side).