BACK DOOR CLOSER ECU INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

A bolt without a torque specification is shown in the standard bolt chart.

Click here

Note

When replacing the multiplex network door ECU, the back door automatic open stop position (memory stopped position) is memorized, so be sure to make a note of the automatic open stop position.

PROCEDURE


  1. INSTALL MULTIPLEX NETWORK DOOR ECU


    1. A01V926C02
      A01V9RL Bolt
      A01V8SA Connector

      Temporarily install the multiplex network door ECU by attaching the guide and clip of the multiplex network door ECU to the door panel.

    2. Install the multiplex network door ECU with the 2 bolts.

      Torque:
      8.4 N*m  { 86 kgf*cm, 74 in.*lbf }

    3. Connect the 2 connectors.

  2. INSTALL BACK DOOR TRIM BOARD ASSEMBLY

    Click here

  3. INSTALL BACK DOOR SIDE GARNISH LH

    Click here

  4. INSTALL BACK DOOR SIDE GARNISH RH

    Tech Tips

    Use the same procedure as for the LH side.

  5. INSTALL BACK DOOR CENTER GARNISH

    Click here

  6. SET MULTIPLEX NETWORK DOOR ECU

    Tech Tips

    When replacing the multiplex network door ECU, be sure to set it to the back door memorized automatic open stop position (memory stopped position) before performing the replacement.

    Click here