HOOD LOCK CONTROL CABLE ASSEMBLY(for RHD) INSTALLATION

PROCEDURE


  1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY


    1. A01V7D6C05
      Text in Illustration
      *1 String

      Tie the string that was passed through the engine compartment room to the end of the hood lock control cable assembly as shown in the illustration.

      Tech Tips

      Use a length of string long enough to pass through the engine compartment room.

    2. Pass the hood lock control cable assembly through the vehicle body, and then attach each clamp.

    3. Untie the string from the hood lock control cable assembly.

      A01V7OTC04
      Text in Illustration
      *1 Hood Lock Control Cable *2 Stopper

  2. INSTALL HOOD LOCK ASSEMBLY


    1. Apply MP grease to the sliding parts of the hood lock assembly.

    2. Connect the hood lock control cable assembly to the hood lock assembly.

    3. Install the hood lock assembly with the 3 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

    4. w/ Engine Hood Courtesy Switch:

      Connect the connector.

  3. INSTALL HOOD LOCK CONTROL CABLE COVER (w/ Cover)


    1. Attach the guide and clip to install the hood lock control cable cover.

  4. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. Connect the hood lock control cable assembly to the hood lock control lever assembly.

    2. Attach the 3 claws to install the hood lock control lever assembly.

  5. INSTALL FUSE BOX OPENING COVER

    Click here

  6. INSTALL COWL SIDE TRIM BOARD RH

    Click here

  7. INSTALL FRONT DOOR SCUFF PLATE RH

    Click here

  8. INSTALL COWL TOP PANEL OUTER SUB-ASSEMBLY

    Click here

  9. INSTALL HOOD TO FRONT FENDER SEAL RH


    1. A01V7Y0

      Attach the 3 clips to install the hood to front fender seal RH.

    2. Install the clip.

  10. INSTALL HOOD TO FRONT FENDER SEAL LH

    Tech Tips

    Use the same procedure described for the RH side.

  11. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

    Click here

  12. INSTALL UPPER RADIATOR AIR GUIDE PLATE

    Click here

  13. INSTALL FRONT BUMPER COVER

    Click here