POWER BACK DOOR SYSTEM FREEZE FRAME DATA

FREEZE FRAME DATA

1. Whenever a DTC is detected, the multiplex network door ECU stores the current vehicle state as Freeze Frame Data.

CHECK FREEZE FRAME DATA

1. Turn the ignition switch off.

2. Connect the GTS to the DLC3.

3. Turn the ignition switch ON.

4. Turn the GTS on.

5. Enter the following menus: Body Electrical / Back Door / Trouble Codes.

   
   Body Electrical > Back Door > Trouble Codes
   Body Electrical > Back Door

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   Half Latch SW	Latch switch signal	ON or OFF	ON: Back door lock motor open-latched OFF: Back door lock motor full-latched or half-latched	Refer to "POWER BACK DOOR OPERATION TIMING CHART"*
   Closer Position SW	Sector switch signal	ON or OFF	ON: Back door lock sector gear in center position (Sector switch on) OFF: Back door lock sector gear out of center position (Sector switch off)	Refer to "POWER BACK DOOR OPERATION TIMING CHART"*
   Pawl Position Switch	Pawl switch signal	ON or OFF	ON: Back door lock motor open-latched OFF: Back door lock motor except open-latched	Refer to "POWER BACK DOOR OPERATION TIMING CHART"*
   Courtesy SW	Back door courtesy switch signal	ON or OFF	ON: Back door open OFF: Back door closed	Refer to "POWER BACK DOOR OPERATION TIMING CHART"*

   
   

   • *: Refer to "POWER BACK DOOR OPERATION TIMING CHART"

     Click here

CLEAR FREEZE FRAME DATA

1. Turn the ignition switch off.

2. Connect the GTS to the DLC3.

3. Turn the ignition switch ON.

4. Turn the GTS on.

5. Clear the DTCs and Freeze Frame Data.

   
   Body Electrical > Back Door > Clear DTCs