PERSONAL LIGHT INSPECTION

PROCEDURE


  1. INSPECT MAP LIGHT ASSEMBLY


    1. A00YWWJC01
      *a

      Component without harness connected

      (Map Light Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      3 (+B1) - 1 (GND) Map light switch LH OFF 10 kΩ or higher
      Map light switch LH ON Below 1 Ω
      Map light switch RH OFF 10 kΩ or higher
      Map light switch RH ON Below 1 Ω
      3 (+B1) - 2 (CTY) Courtesy switch OFF position 10 kΩ or higher
      Courtesy switch DOOR position Below 1 Ω

      If the result is not as specified, replace the map light assembly.