TILT SENSOR INSTALLATION

PROCEDURE

1. INSTALL YAW RATE SENSOR ASSEMBLY

   
   

   1. Install the yaw rate sensor assembly with the 2 bolts.

      Torque:

      14.5 N*m  { 148 kgf*cm, 11 ft.*lbf }

      Note

      
      

      • Do not damage the yaw rate sensor assembly.

      • Make sure that the yaw rate sensor assembly is installed securely.

   2. Connect the connector.

2. INSTALL YAW RATE SENSOR BRACKET

   
   

   1. Attach the guide.

   2. Install the yaw rate sensor bracket with the bolt.

      Torque:

      14.5 N*m  { 148 kgf*cm, 11 ft.*lbf }

   3. Return the floor carpet to its original position.

3. INSTALL LOWER CENTER PILLAR GARNISH LH

   Click here

4. INSTALL OUTER LAP BELT ANCHOR COVER

   Click here

5. INSTALL REAR DOOR SCUFF PLATE LH

   Click here

6. INSTALL FRONT DOOR SCUFF PLATE LH

   Click here

7. INSTALL COWL SIDE TRIM BOARD LH

   Click here

8. INSTALL FRONT SEAT ASSEMBLY LH

   
   

   1. for Manual Seat:

      Click here

   2. for Power Seat:

      Click here

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here