TILT SENSOR REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE FRONT SEAT ASSEMBLY LH


    1. for Manual Seat:

      Click here

    2. for Power Seat:

      Click here

  4. REMOVE COWL SIDE TRIM BOARD LH

    Click here

  5. REMOVE FRONT DOOR SCUFF PLATE LH

    Click here

  6. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  7. REMOVE OUTER LAP BELT ANCHOR COVER

    Click here

  8. REMOVE LOWER CENTER PILLAR GARNISH LH

    Click here

  9. REMOVE YAW RATE SENSOR BRACKET


    1. Partially remove the floor carpet.

    2. A01V95R

      Remove the bolt.

    3. Detach the guide and remove the yaw rate sensor bracket.

  10. REMOVE YAW RATE SENSOR ASSEMBLY


    1. A01VAOD

      Disconnect the connector.

    2. Remove the 2 bolts and yaw rate sensor assembly.

      Note

      Do not remove the yaw rate sensor assembly sensor from the bracket.