REAR SEAT ASSEMBLY(for RH Side) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the seatback frame, seat cushion frame and reclining adjuster may injure your hands.

PROCEDURE


  1. REMOVE REAR SEAT FRONT BRACKET COVER RH


    1. A01QUH5

      Using a screwdriver, detach the 4 claws.

      Tech Tips

      Tape the screwdriver tip before use.

    2. Detach the 2 guides and remove the rear seat front bracket cover RH in the direction shown by the arrow in the illustration.

  2. REMOVE REAR SEAT NO. 2 LEG SIDE COVER


    1. A01QP6N

      Using a screwdriver, detach the 4 claws to remove the rear seat No. 2 leg side cover.

      Tech Tips

      Tape the screwdriver tip before use.

  3. REMOVE REAR SEAT ASSEMBLY RH


    1. A01QPHJ

      Remove the 2 bolts on the front side of the seat.

    2. A01QT52

      w/ Seat Heater System:


      1. Disconnect the connector.

      2. Detach the wire harness clamp.

    3. A01QREKC01
      *1 Rubber Band

      w/ Seat Belt Warning System:

      Disconnect the 2 connectors.

    4. Pass the rear seat center lap type belt assembly RH through the rubber band of the separate type rear seat cushion cover.

    5. Remove the 3 bolts on the rear side of the seat.

    6. Fully tilt the seatback forward. Then remove the seat.

      Note

      Be careful not to damage the vehicle body.

  4. REMOVE SEAT LEG BRACKET

    A01QOGU

    1. Detach the clamp and remove the 4 bolts.

    2. Detach the guide to remove the seat leg bracket.