IMMOBILISER SYSTEM(w/o Entry and Start System), Diagnostic DTC:B2795

DTC Code DTC Name
B2795 Unmatched Key Code

DESCRIPTION

This DTC is stored when a key with a different vehicle serial number is inserted into the ignition key cylinder.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
B2795 Unmatched Key Code A key with a different vehicle serial number is inserted into the ignition key cylinder (1 trip detection logic*).

  • Key

  • Transponder key ECU assembly

    DTC Output Confirmation Operation:

  • Insert the key into the ignition key cylinder.

Vehicle Condition and Fail-safe Operation when Malfunction Detected
Vehicle Condition when Malfunction Detected Fail-safe Operation when Malfunction Detected
Engine cannot be started -
Related Data List and Active Test Items
DTC No. Data List and Active Test
B2795 -

CAUTION / NOTICE / HINT

Note


  • If the transponder key ECU assembly or key is replaced, refer to the Service Bulletin.

  • After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".

  • When using the GTS with the vehicle ignition switch off, connect the GTS to the vehicle and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select the Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Immobiliser. While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

PROCEDURE


  1. CLEAR DTC


    1. Clear the DTCs.

      Click here


      Body Electrical > Immobiliser > Clear DTCs
      Result
      Proceed to
      NEXT

    NEXT

  2. CHECK FOR DTC


    1. Insert and remove each registered key one at a time, and check for DTCs each time.

      Click here


      Body Electrical > Immobiliser > Trouble Codes

      Tech Tips


      • Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.

      • If DTC B2795 is stored, check for DTCs with the next key after clearing the DTCs.

      Result
      Proceed to
      DTC B2795 is not output
      DTC B2795 is output for all of the keys
      DTC B2795 is output for any of the keys

    DTC B2795 is not output

    USE SIMULATION METHOD TO CHECK Click here

    DTC B2795 is output for all of the keys

    REPLACE TRANSPONDER KEY ECU ASSEMBLY

    DTC B2795 is output for any of the keys

  3. CHECK OPERATION (IGNITION SWITCH)


    1. Check that the ignition switch can be turned to ON using the key for which the DTC was stored.

      OK
      Ignition switch can be turned to ON using the key (for which the DTC was stored).
      Result
      Proceed to
      OK
      NG

    NG

    REPLACE KEY FOR WHICH DTC WAS OUTPUT

    OK

  4. REREGISTRATION


    1. Clear the DTCs.

      Click here


      Body Electrical > Immobiliser > Clear DTCs

    2. Reregister the key ID code with the transponder key ECU assembly.

      Tech Tips

      Refer to the Service Bulletin.

      OK
      Registration procedure can be completed.
      Result
      Proceed to
      OK
      NG

    OK

    END (KEY REGISTRATION FAILURE)

    NG

    REPLACE KEY FOR WHICH DTC WAS OUTPUT