REAR DOOR LOCK INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart.

    Click here

PROCEDURE


  1. INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH

    Click here

  2. INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

    Click here

  3. INSTALL REAR DOOR WITH MOTOR LOCK ASSEMBLY LH

    Note


    • When reusing the removed rear door lock assembly, replace the door lock wiring harness seal on the connector with a new one.

    • Do not allow grease or dust to contact the door lock wiring harness seal surface of the connector.

    • Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water intrusion. This may result in a malfunction of the rear door lock assembly.


    1. Apply MP grease to the sliding parts of the rear door with motor lock assembly LH.

    2. A01V6WK

      Install a new door lock wiring harness seal to the rear door with motor lock assembly LH.

    3. A01V8F1C01
      *a Upward

      Insert the rear door with motor lock assembly LH into the rear door outside handle frame release plate, and set it to the rear door panel.

    4. Make sure that the rear door outside handle frame release plate is securely connected to the rear door with motor lock assembly LH.

    5. A01V7XVC01
      *A w/o Double Locking System
      *B w/ Double Locking System

      Using a T30 "TORX" socket wrench, install the rear door with motor lock assembly LH with the 3 screws.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

    6. Connect the connector.

  4. INSTALL REAR DOOR GLASS RUN LH

    Click here

  5. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

    Click here

  6. INSTALL REAR DOOR QUARTER WINDOW GLASS LH

    Click here

  7. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

    Click here

  8. INSTALL REAR DOOR SERVICE HOLE COVER LH

    Click here

  9. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  10. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  11. INSTALL DOOR ASSIST GRIP COVER LH

    Click here

  12. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

  13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  14. CHECK POWER WINDOW CONTROL SYSTEM

    Click here

  15. CHECK POWER DOOR LOCK CONTROL SYSTEM

    Click here