FRONT DOOR LOCK REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    After turning the ignition switch off, waiting time may be required before disconnecting the cablefrom the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

    Click here

  4. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

  5. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  6. REMOVE FRONT DOOR ASSIST GRIP COVER LH

    Click here

  7. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  8. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  9. REMOVE FRONT DOOR SERVICE HOLE COVER LH

    Click here

  10. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

    Click here

  11. REMOVE FRONT DOOR GLASS RUN LH

    Click here

  12. REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH

    Click here

  13. REMOVE FRONT DOOR OUTSIDE HANDLE COVER LH (for Driver Side)

    Click here

  14. REMOVE FRONT DOOR WITH MOTOR LOCK ASSEMBLY LH


    1. A01V8IGC01
      *A w/o Double Locking System
      *B w/ Double Locking System

      Disconnect the connector.

    2. Using a T30 "TORX" socket wrench, remove the 3 screws.

    3. A01V8MTC01
      *1 Front Door Lock Open Rod LH
      A01V9RL Downward

      Slide the front door with motor lock assembly LH downward, and remove the front door with motor lock assembly LH and cables as a unit.

      Tech Tips

      Remove the front door lock assembly LH through the service hole.

    4. A01VA9X

      Remove the door lock wiring harness seal from the front door with motor lock assembly LH.

  15. REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH

    Click here

  16. REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

    Click here