NETWORK GATEWAY ECU(for RHD) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  4. REMOVE FUSE BOX OPENING COVER

    Click here

  5. REMOVE ECU INTEGRATION BOX RH

    Click here

  6. REMOVE NETWORK GATEWAY ECU


    1. A01V9WIC01
      A01V9NY Protective Tape

      Using a screwdriver, insert it to the ECU integration box RH and detach the 2 claws.

      Tech Tips

      Tape the screwdriver tip before use.

    2. Pull out and remove the network gateway ECU from the ECU integration box RH.