PRE-CRASH SAFETY SYSTEM WARNING BUZZER REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL

    Click here

  4. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

    Click here

  5. REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

    Click here

  6. REMOVE TELLTALE LIGHT ASSEMBLY

    Click here

  7. REMOVE STEREO OPENING COVER (w/o Audio)

    Click here

  8. REMOVE RADIO RECEIVER ASSEMBLY (w/ Audio, for Radio Receiver Type)

    Click here

  9. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY (w/ Audio, for Radio and Display Type)

    Click here

  10. REMOVE NAVIGATION RECEIVER (w/ Navigation System)

    Click here

  11. REMOVE SKID CONTROL BUZZER (PRE-CRASH SAFETY SYSTEM WARNING BUZZER)


    1. A01V7T5

      Using a clip remover, detach the clamp and remove the skid control buzzer (pre-crash safety system warning buzzer).

    2. Disconnect the connector.