REAR AIRBAG SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR AIRBAG SENSOR LH


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Insert the pin (stopper) into the body hole to install the rear airbag sensor to the vehicle with the nut.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

      • When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • Make sure that the pin (stopper) is securely inserted into the body hole.

      • Tighten the nut while holding the rear airbag sensor because the rear airbag sensor pin (stopper) is easily damaged.

    4. Connect the connector to the rear airbag sensor LH.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.


      1. While holding the outer housing, be sure to engage the connectors until they are locked and check that the outer housing is in its original position (when locking, make sure that a click sound can be heard).

        A01V6Q1C08
        *1 Outer Housing - -

    5. Check that there is no looseness in the installation parts of the rear airbag sensor LH.

  2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH

    Click here

  3. INSTALL DECK TRIM SERVICE HOLE COVER

    Click here

  4. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

  5. INSTALL REAR DOOR SCUFF PLATE LH

    Click here

  6. INSTALL REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE (w/o Spare Tire, for Compact Spare Tire)

    Click here

  7. INSTALL REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE (w/ Grand Spare Tire)

    Click here

  8. INSTALL REAR FLOOR FINISH PLATE (w/o Spare Tire, for Compact Spare Tire)

    Click here

  9. INSTALL REAR DECK TRIM COVER (w/ Grand Spare Tire)

    Click here

  10. INSTALL REAR NO. 3 FLOOR BOARD

    Click here

  11. INSTALL DECK FLOOR BOX LH

    Click here

  12. INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire, for Compact Spare Tire)

    Click here

  13. INSTALL DECK BOARD ASSEMBLY (w/ Grand Spare Tire)

    Click here

  14. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

    Click here

  15. INSTALL PACKAGE TRAY TRIM POCKET SUB-ASSEMBLY (w/ Partition Net)

    Click here

  16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  17. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  18. CHECK SRS WARNING LIGHT

    Click here