REAR AIRBAG SENSOR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE PACKAGE TRAY TRIM POCKET SUB-ASSEMBLY (w/ Partition Net)

    Click here

  4. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

    Click here

  5. REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire, for Compact Spare Tire)

    Click here

  6. REMOVE DECK BOARD ASSEMBLY (w/ Grand Spare Tire)

    Click here

  7. REMOVE DECK FLOOR BOX LH

    Click here

  8. REMOVE REAR NO. 3 FLOOR BOARD

    Click here

  9. REMOVE REAR FLOOR FINISH PLATE (w/o Spare Tire, for Compact Spare Tire)

    Click here

  10. REMOVE REAR DECK TRIM COVER (w/ Grand Spare Tire)

    Click here

  11. REMOVE REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE (w/o Spare Tire, for Compact Spare Tire)

    Click here

  12. REMOVE REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE (w/ Grand Spare Tire)

    Click here

  13. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  14. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

  15. REMOVE DECK TRIM SERVICE HOLE COVER

    Click here

  16. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

    Click here

  17. REMOVE REAR AIRBAG SENSOR LH


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Disconnect the connector from the rear airbag sensor LH.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.


      1. Push the housing lock and slide the outer housing. (At this time, the connector cannot be disconnected yet.)

      2. Push the housing lock again and disconnect the connector.

        Note

        Do not push down the part (A) shown in the illustration when disconnecting.

        A01VA6LC11
        *1 Housing Lock *2 Outer Housing
    4. A01V8AB

      Remove the nut and rear airbag sensor LH.

      Note

      Loosen the nut while holding the rear airbag sensor LH because the rear airbag sensor pin (stopper) is easily damaged.