AIRBAG CUT-OFF SWITCH REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the front passenger side of RHD and LHD vehicles.

  • The procedures listed below are for the front passenger side of LHD vehicles.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY


    1. A01V6VWC01
      *1 Protective Tape

      Put protective tape around the airbag cut off switch cylinder sub-assembly.

    2. Using a screwdriver, detach the 2 claws.

      Tech Tips

      Tape the screwdriver tip before use.

    3. Disconnect the connector to remove the airbag cut off switch cylinder sub-assembly.