SRS SEAT CUSHION AIRBAG ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:


  • Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.

  • If the cushion airbag was deployed, replace the front seat airbag sub-assembly RH, separate type front seat cushion spring assembly, separate type front seat cushion cover and separate type front seat cushion pad with the necessary parts in accordance with the extent of the collision damage.

PROCEDURE


  1. INSTALL FRONT SEAT AIRBAG SUB-ASSEMBLY RH


    1. Install the front seat airbag assembly LH with 3 new nuts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

      CAUTION:


      • The nuts must not be reused.

      • Make sure that the separate type front seat cushion spring assembly is not deformed. If it is, replace it with a new one.

    2. Attach the 3 clamps to the separate type front seat cushion spring assembly.

  2. INSTALL SEPARATE TYPE SEAT CUSHION COVER WITH PAD

    Click here

  3. INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY

    Click here

  4. INSTALL FRONT INNER SEAT CUSHION SHIELD RH

    Click here

  5. INSTALL FRONT SEAT CUSHION SHIELD RH

    Click here

  6. INSTALL RECLINING ADJUSTER RELEASE HANDLE RH

    Click here

  7. INSTALL FRONT SEAT ASSEMBLY RH

    Click here

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  9. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  10. CHECK SRS WARNING LIGHT

    Click here