FRONT PASSENGER AIRBAG ASSEMBLY(for Dual Type) REMOVAL

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

    Click here

  4. REMOVE INSTRUMENT PANEL PASSENGER WITHOUT DOOR AIRBAG ASSEMBLY

    CAUTION:

    When storing the instrument panel passenger without door airbag assembly, keep the airbag deployment side facing upward.


    1. A01V8HN

      Remove the 2 screws.

    2. While bending the front of the airbag door, detach the 3 hooks.

    3. Detach the 3 hooks from the rear of the airbag door to remove the instrument panel passenger without door airbag assembly.

  5. REMOVE NO. 2 INSTRUMENT PANEL WIRE


    1. A01V9UMC01
      *1 Protective Tape
      *2 Connector Lock

      Detach the connector clamp.

    2. Using a screwdriver with the tip wrapped with protective tape, release the 3 airbag connector locks.

    3. Disconnect the 3 airbag connectors to remove the No. 2 instrument panel wire from the instrument panel passenger without door airbag assembly.

      CAUTION:

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.