KNEE AIRBAG ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

   
   

   1. Check that the ignition switch is off.

   2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   3. 

      *1	Connector Lock

      Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

   4. Push in the connector lock to install the airbag connector.

   5. Attach the clamp.

   6. Attach the 8 claws to install the lower No. 1 instrument panel airbag assembly.

   7. Install the 4 bolts.

      Torque:

      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.

2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

4. PERFORM DIAGNOSTIC SYSTEM CHECK

   Click here

5. CHECK SRS WARNING LIGHT

   Click here