SPIRAL CABLE(for Single Type) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the driver side of RHD and LHD vehicles.

  • The procedures listed below are for the driver side of LHD vehicles.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  5. REMOVE STEERING COLUMN COVER

    Click here

  6. REMOVE SPIRAL CABLE SUB-ASSEMBLY

    Note


    • Do not replace the spiral cable with the battery connected and the ignition switch on (IG).

    • Do not rotate the spiral cable with the battery connected and the ignition switch on (IG).

    • w/ Vehicle Stability Control System:

      Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.


    1. A01V791C01
      *1 Slider

      Slide the slider to release the lock, and then disconnect the yellow airbag connector from the spiral cable sub-assembly.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

    2. Disconnect the connector from the spiral cable sub-assembly.

    3. A01V9EP

      Detach the 3 claws to remove the spiral cable sub-assembly.