STEERING PAD(for Dual Type) REMOVAL

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE LOWER NO. 2 STEERING WHEEL COVER


    1. A01VA1NC01
      *1 Protective Tape

      Using a screwdriver, detach the claw and guide to remove the lower No. 2 steering wheel cover.

      Tech Tips

      Tape the screwdriver tip before use.

  4. REMOVE STEERING PAD ASSEMBLY

    CAUTION:

    When storing the steering pad, keep the airbag deployment side facing upward.


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Using a T30H "TORX" screwdriver, push in the 3 torsion springs to detach the 3 claws.

      Note


      • Do not drop the steering pad assembly.

      • When disconnecting the steering pad, do not pull the airbag wire harness.

      Tech Tips

      Insert the T30H "TORX" screwdriver from the installation hole for thr lower No. 2 steering wheel cover and 2 service holes.

      A01V9J7C01
      *1 Torsion Spring *2 T30H "TORX" Screwdriver
    4. A01VA6ZC01
      *1 Horn Connector
      *2 Airbag Connector
      *3 Connector Lock
      *4 Protective Tape

      Disconnect the horn connector from the steering pad assembly.

    5. Using a screwdriver, release the 2 airbag connector locks.

      Tech Tips

      Tape the screwdriver tip before use.

    6. Disconnect the 2 airbag connectors to remove the steering pad assembly as shown in the illustration.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.