STEERING PAD(for Single Type) REMOVAL

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE LOWER NO. 2 STEERING WHEEL COVER


    1. Using a screwdriver, detach the claw and guide to remove the lower No. 2 steering wheel cover.

      Tech Tips

      Tape the screwdriver tip before use.

      A01V9KYC01
      *A w/ Cruise Control System *B w/o Cruise Control System
      *1 Protective Tape - -

  4. REMOVE STEERING PAD ASSEMBLY

    CAUTION:

    When storing the steering pad, keep the airbag deployment side facing upward.


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Using a T30H "TORX" screwdriver, push in the 3 torsion springs to detach the 3 claws.

      Note


      • Do not drop the steering pad assembly.

      • When disconnecting the steering pad, do not pull the airbag wire harness.

      Tech Tips

      Insert the T30H "TORX" screwdriver from the installation hole for thr lower No. 2 steering wheel cover and 2 service holes.

      A01V9J7C01
      *1 Torsion Spring *2 T30H "TORX" Screwdriver
    4. A01VACUC01
      *1 Horn Connector
      *2 Airbag Connector
      *3 Connector Lock
      *4 Protective Tape

      Disconnect the horn connector from the steering pad assembly.

    5. Using a screwdriver, release the airbag connector lock.

      Tech Tips

      Tape the screwdriver tip before use.

    6. Disconnect the airbag connector to remove the steering pad assembly as shown in the illustration.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.