MAIN BODY ECU(for LHD) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

    Click here

  4. REMOVE LOWER INSTRUMENT PANEL

    Click here

  5. REMOVE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


    1. A01V6T6

      Disconnect the connectors.

    2. Remove the 2 bolts and instrument panel junction block assembly.

  6. REMOVE MULTIPLEX NETWORK BODY ECU (MAIN BODY ECU)

    Note

    If the multiplex network body ECU (main body ECU) is replaced, replace it with a new one.


    1. A01V9SOC01
      *1 Multiplex Network Body ECU (Main Body ECU)
      *2 Claw of Junction Block
      *3 Protective Tape

      Press the claw of the junction block as shown in the illustration to release the lock.

    2. With the junction block lock released, insert a screwdriver with its tip wrapped with protective tape horizontally between the multiplex network body ECU (main body ECU) and junction block.

      Note

      Use a screwdriver with a diameter of between 5.0 mm (0.197 in.) and 6.3 mm (0.248 in.) and a length of approximately 90 mm (3.54 in.).

    3. A01V8EEC01
      *1 Protective Tape

      Using the screwdriver, carefully raise the multiplex network body ECU (main body ECU) up to the position where the connector becomes disengaged.

      Note


      • Do not insert the screwdriver opening between the junction block and the connector of the multiplex network body ECU (main body ECU).

      • Do not twist the screwdriver to raise the multiplex network body ECU (main body ECU).

    4. A01V9TIN01

      Raise the multiplex network body ECU (main body ECU) as shown by the arrow (1), and then pull it out as shown by the arrow (2) in the illustration.

      Note

      Do not touch the ECU connector.