GENERATOR(for 100 A Type) COMPONENTS
ILLUSTRATION
| *1 | GENERATOR ASSEMBLY | *2 | NO. 1 ENGINE UNDER COVER |
| *3 | NO. 2 CYLINDER HEAD COVER | *4 | REAR ENGINE UNDER COVER RH |
| *5 | V-RIBBED BELT | *6 | TERMINAL CAP |
| *7 | WIRE HARNESS CLAMP BRACKET | *8 | ADJUSTING BAR |
 |
Specified torque: N*m (kgf*cm, ft.*lbf) | - | - |
ILLUSTRATION
| *1 | GENERATOR BEARING COVER PACKING | *2 | GENERATOR BRUSH HOLDER ASSEMBLY |
| *3 | GENERATOR COIL ASSEMBLY | *4 | GENERATOR DRIVE END FRAME BEARING |
| *5 | GENERATOR PULLEY CAP | *6 | GENERATOR PULLEY WITH CLUTCH |
| *7 | GENERATOR REAR END COVER | *8 | GENERATOR ROTOR ASSEMBLY |
| *9 | TERMINAL INSULATOR | *10 | GENERATOR DRIVE END FRAME ASSEMBLY |
| *11 | RETAINER PLATE | - | - |
| |
Specified torque: N*m (kgf*cm, ft.*lbf) | * | For use with SST |
| ● | Non-reusable part | - | - |