GENERATOR INSTALLATION

PROCEDURE

1. INSTALL GENERATOR ASSEMBLY

   
   

   1. Install the wire harness clamp bracket with the bolt.

      Torque:

      7.7 N*m  { 79 kgf*cm, 68 in.*lbf }

   2. Temporarily install the generator assembly and No. 2 generator bracket with the 3 bolts.

   3. 

      	Bolt A
      	Bolt B

      Tighten the 3 bolts in the order shown in the illustration to install the generator assembly and No. 2 generator bracket.

      Torque:

      for bolt A

      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

      for bolt B

      25 N*m  { 255 kgf*cm, 18 ft.*lbf }

   4. Connect the wire harness to terminal B with the nut.

      Torque:

      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

   5. Install the terminal cap.

   6. Connect the connector and attach the wire harness clamp.

2. INSTALL V-RIBBED BELT

   Click here

3. INSPECT V-RIBBED BELT

   Click here

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

5. INSTALL REAR ENGINE UNDER COVER RH

   Click here

6. INSTALL NO. 1 ENGINE UNDER COVER

   Click here

7. INSTALL NO. 2 CYLINDER HEAD COVER

   Click here