BATTERY CURRENT SENSOR REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. REMOVE BATTERY STATE SENSOR ASSEMBLY (BATTERY STATE SENSOR ASSEMBLY WITH NEGATIVE BATTERY TERMINAL)


    1. A01V88X

      Remove nut and disconnect the No. 3 engine wire from the battery state sensor assembly.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

      Click here

    2. Disconnect the connector from the battery state sensor assembly.

    3. Loosen the nut and remove the battery state sensor assembly from the battery.

    4. A01V7MN

      Detach the 2 claws and remove the battery state sensor assembly from the battery current sensor holder.