GENERATOR REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE NO. 1 ENGINE COVER

    Click here

  4. REMOVE FAN AND GENERATOR V BELT

    Click here

  5. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH

    Click here

  6. REMOVE WIRE HARNESS CLAMP BRACKET (for DPF)


    1. A01V9YT

      Disconnect the air fuel ratio sensor connector and detach the wire harness clamp.

    2. Remove the bolt and wire harness clamp bracket.

  7. REMOVE GENERATOR ASSEMBLY


    1. A01VB5NC01
      *A for CCo
      *B for DPF

      Detach the wire harness clamp and disconnect the generator connector.

    2. Remove the terminal cap.

    3. Remove the nut and disconnect the terminal B.

    4. Remove the bolt and disconnect the wire harness.

    5. A01VAPX

      Remove the 3 bolts and generator assembly.