REAR VIEW MONITOR SYSTEM(for Radio and Display Type) HOW TO PROCEED WITH TROUBLESHOOTING

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tech Tips


  • Use these procedures to troubleshoot the rear view monitor system.

  • *: Use the GTS

PROCEDURE


  1. VEHICLE BROUGHT TO WORKSHOP

    Result
    Proceed to
    NEXT

    NEXT

  2. CUSTOMER PROBLEM ANALYSIS

    Result
    Proceed to
    NEXT

    NEXT

  3. INSPECT BATTERY VOLTAGE


    1. Measure the battery voltage with the ignition switch off.

      Standard voltage
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.

      Result
      Proceed to
      NEXT

    NEXT

  4. CHECK AUDIO AND VISUAL SYSTEM*


    1. Refer to DTC Check/Clear procedures of the audio and visual system.

      Click here


      Body Electrical > Navigation System > Trouble Codes
      Result
      Proceed to
      DTC is not output
      DTC is output

    DTC is output

    GO TO AUDIO AND VISUAL SYSTEM Click here

    DTC is not output

  5. CHECK FOR DTC*


    1. Check for DTCs and note any codes that are output.

    2. Clear the DTC

      Click here


      Body Electrical > Navigation System > Clear DTCs

    3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

      Click here


      Body Electrical > Navigation System > Trouble Codes
      Result
      Proceed to
      DTCs are not output.
      DTCs are output.

      Tech Tips

      Even if the malfunction symptom is not confirmed, check for DTCs. This is because the system stores history DTCs.


    DTCs are output.

    GO TO DIAGNOSTIC TROUBLE CODE CHART Click here

    DTCs are not output.

  6. PROBLEM SYMPTOMS TABLE


    1. Refer to the problem symptoms table.

      Click here

      Result
      Proceed to
      Fault is not listed in problem symptoms table
      Fault is listed in problem symptoms table

    Fault is listed in problem symptoms table

    ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE

    Fault is not listed in problem symptoms table

  7. BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW


    1. Terminals of ECU.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  8. ADJUST, REPAIR OR REPLACE

    Result
    Proceed to
    NEXT

    NEXT

  9. CONFIRMATION TEST

    Result
    Proceed to
    NEXT

    NEXT

    END