PARKING ASSIST MONITOR SYSTEM(for Camera built-in ECU) DTC CHECK / CLEAR

CHECK DTC (USING GTS)

1. Connect the GTS to the DLC3.

2. Turn the ignition switch to ON.

3. Turn the GTS on.

4. Enter the following menus:

   
   

   • Chassis / IPA/Parking Assist Monitor / Trouble Codes

   • Body Electrical / Navigation System / Trouble Codes

5. Check for DTCs, and then write them down.

6. Check for DTCs.

   
   Chassis > IPA/Parking Assist Monitor > Trouble Codes
   Body Electrical > Navigation System > Trouble Codes

   Note

   The navigation receiver assembly*1 or radio and display receiver assembly*2 outputs DTCs for the following system. When DTCs other than those in Diagnostic Trouble Code Chart for the parking assist monitor system are output, refer to Diagnostic Trouble Code Chart for the relevant systems.

   
   

   • *1: for Navigation Receiver Type

   • *2: for Radio and Display Type

   System	Proceed to
   Navigation System (for Navigation Receiver Type)	Click here
   Audio and Visual System (for Radio and Display Type)	Click here

CLEAR DTC (USING GTS)

1. Connect the GTS to the DLC3.

2. Turn the ignition switch to ON.

3. Turn the GTS on.

4. Enter the following menus:

   
   

   • Chassis / IPA/Parking Assist Monitor / Trouble Codes

   • Body Electrical / Navigation System / Trouble Codes

5. Clear the DTCs.

   
   Chassis > IPA/Parking Assist Monitor > Clear DTCs
   Body Electrical > Navigation System > Clear DTCs

CHECK DTC (USING DIAGNOSTIC MODE)

1. Refer to navigation system (for Navigation Receiver Type).

   Click here

2. Refer to audio and visual system (for Radio and Display Type).

   Click here

CLEAR DTC (USING DIAGNOSTIC MODE)

1. Refer to navigation system (for Navigation Receiver Type).

   Click here

2. Refer to audio and visual system (for Radio and Display Type).

   Click here