PARKING ASSIST MONITOR SYSTEM(for Camera built-in ECU) DIAGNOSIS SYSTEM


  1. PARKING ASSIST MONITOR DIAGNOSIS SYSTEM


    1. For parking assist monitor system diagnosis, signals received by the navigation receiver assembly (for navigation receiver type) or radio and display receiver assembly (for radio and display type) can be checked and the parking assist monitor system can be calibrated, adjusted and checked using the navigation receiver assembly (for navigation receiver type) or radio and display receiver assembly (for radio and display type).

      Note

      Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

      Click here

      Tech Tips

      The displayed items may differ depending on vehicle specifications.

  2. DIAGNOSIS SCREEN TRANSITION


    1. During parking assist monitor system initialization

      A01CZ24E01
      Example
      *1 Start diagnostic mode
      A01CX1U

    2. After parking assist monitor system initialization

      A01CYTLE01
      Example
      *1 Start diagnostic mode
      A01CW78

  3. VEHICLE SIGNAL CHECK


    1. Start diagnostic mode.

      Click here

    2. A01CYNP

      Select "Function Check/Setting" on the "Service Menu" screen to display the "Function Check/Setting I" screen.

    3. A01CW0Q

      Select "Vehicle Signal" on the "Function Check/Setting I" screen.

    4. A01CXR4

      Vehicle Signal Check Mode


      1. When the "Vehicle Signal Check Mode" screen is displayed, check the item displayed for "REV" and "SPEED".

        Tech Tips


        • Only conditions having inputs are displayed.

        • This screen displays vehicle signals input to the navigation receiver assembly*1 or radio and display receiver assembly*2.

          *1: for Navigation Receiver Type

          *2: for Radio and Display Type

    5. Finish diagnostic mode.

      Click here

  4. CAR SIGNAL CHECK (parking assist monitor system input signals)


    1. Start diagnostic mode.

      Click here


      1. A01CYNP

        Select "Function Check/Setting" on the "Service Menu" screen to display the "Function Check/Setting I" screen.

      2. A01CYK6

        Select "Camera Setting" on the "Function Check/Setting I" screen.

        Parking Assist Monitor System Initialization Screen Transition
        Not performed Car Signal Check screen
        Performed Mode Setting Screen
      3. A01CX48

        When the screen changes to the "Mode Setting" screen, select "Back Camera Setting" to display the "Car Signal Check" screen.

        Tech Tips

        To select a grayed out item, select and hold the item for 2 seconds or more.

    2. A01CY52

      Car Signal Check


      1. On the "Car Signal Check" screen, it is possible to inspect the state of signals and check the settings.

        Item Inspection Detail Note
        CAN CAN communication status signal input When "CHK" (red) is displayed, selecting "Next" will not change to the next screen.

        Tech Tips


        • When "CHK" (red) is displayed, perform inspections based on the result of the following inspections.


        • If performing the adjustment after proceeding to the next screen, confirm that all items display "OK" (blue) before selecting "Next".

    3. CAN inspection

      Tech Tips

      If "CHK" (red) is displayed for "CAN", check for DTCs and perform troubleshooting based on the output DTCs.

      Click here

    4. Finish diagnostic mode.

      Click here

  5. CALIBRATION WHEN SERVICING VEHICLE

    Note

    Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

    Click here