PARKING ASSIST MONITOR SYSTEM(for Navigation Receiver Type) Guide Lines are Displayed with Vehicle Center Line

DESCRIPTION

The television camera assembly can create parking guide lines. Since this function is not necessary on vehicles with the parking assist monitor system, the guide line creation function of the television camera assembly is disabled.

WIRING DIAGRAM

A01QSMPE03
*a Television Camera Assembly

CAUTION / NOTICE / HINT

Note


  • When "System initializing" is displayed on the navigation ECU sub-assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point Click here.

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed Click here.

PROCEDURE


  1. CHECK SCREEN MODE


    1. A01QTPEE01

      Check the back guide monitor screen.

      Result
      Result Proceed to
      Guide lines are displayed with vehicle center line. A
      Guide lines are displayed without vehicle center line. B

    B

    USE SIMULATION METHOD TO CHECK (A WIRE MAY BE OPEN) Click here

    A

  2. CHECK HARNESS AND CONNECTOR (TELEVISION CAMERA ASSEMBLY - BODY GROUND)


    1. Disconnect the U6 television camera assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      U6-1 (CURT) - Body ground Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE TELEVISION CAMERA ASSEMBLY Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR