PARKING ASSIST MONITOR SYSTEM(for Navigation Receiver Type), Diagnostic DTC:C1626

DTC Code DTC Name
C1626 Steering Angle Sensor Failure

DESCRIPTION

This DTC is stored if the navigation ECU sub-assembly receives a signal via CAN communication from the spiral with sensor cable sub-assembly that indicates an internal malfunction.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1626 Steering Angle Sensor Failure A fail flag is transmitted from the spiral with sensor cable sub-assembly.

  • Spiral with sensor cable sub-assembly

  • Navigation ECU sub-assembly

CAUTION / NOTICE / HINT

Note


  • When "System initializing" is displayed on the navigation ECU sub-assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point Click here.

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed Click here.

PROCEDURE


  1. REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY


    1. Replace the spiral with sensor cable sub-assembly.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  2. CHECK DTC


    1. Clear the DTCs Click here.

    2. Check for DTCs Click here.

      Result
      Proceed to
      DTC C1626 is not output
      DTC C1626 is output

    DTC C1626 is not output

    END (SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY IS DEFECTIVE)

    DTC C1626 is output

    REPLACE NAVIGATION ECU SUB-ASSEMBLY Click here