PARKING ASSIST MONITOR SYSTEM(for Navigation Receiver Type), Diagnostic DTC:C1694

DTC Code DTC Name
C1694 Steering Angle Initialization Incomplete

DESCRIPTION


DTC No. Detection Item DTC Detection Condition Trouble Area
C1694 Steering Angle Initialization Incomplete Maximum steering angle has not been memorized (steering angle setting is incomplete)

  • Steering angle setting

  • Navigation ECU sub-assembly

CAUTION / NOTICE / HINT

Note


  • When "System initializing" is displayed on the navigation ECU sub-assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point Click here.

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed Click here.

PROCEDURE


  1. ADJUST SETTINGS (STEERING ANGLE SETTING)


    1. Perform steering angle setting.


      1. Steering angle setting Click here.

      Result
      Proceed to
      NEXT

    NEXT

  2. CHECK DTC


    1. Clear the DTCs Click here.

    2. Check for DTCs Click here.

      OK
      DTC C1694 is not output.

      Tech Tips


      • If DTC C1694 is output, perform the steering angle setting again.

      • If DTC C1694 is still output after performing the steering angle setting 3 times, replace the navigation ECU sub-assembly.

      Result
      Proceed to
      DTC C1694 is not output
      DTC C1694 is output

    DTC C1694 is not output

    END

    DTC C1694 is output

    REPLACE NAVIGATION ECU SUB-ASSEMBLY Click here