PARKING ASSIST MONITOR SYSTEM(for Navigation Receiver Type) HOW TO PROCEED WITH TROUBLESHOOTING

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT


PROCEDURE


  1. VEHICLE BROUGHT TO WORKSHOP

    Result
    Proceed to
    NEXT

    NEXT

  2. INSPECT BATTERY VOLTAGE


    1. Measure the battery voltage with the ignition switch off.

      Standard voltage
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.

      Result
      Proceed to
      NEXT

    NEXT

  3. CHECK IF SAME SYMPTOM APPEARS IN OTHER SYSTEM


    1. Refer to the navigation system.

      Click here

      Result
      Proceed to
      Navigation system is normal
      Navigation system is abnormal

    Navigation system is abnormal

    GO TO NAVIGATION SYSTEM Click here

    Navigation system is normal

  4. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*


    1. Use the GTS to check if the CAN communication system is functioning normally.

      Click here

      Result
      Proceed to
      CAN DTCs are not output.
      CAN DTCs are output.

    CAN DTCs are output.

    GO TO CAN COMMUNICATION SYSTEM Click here

    CAN DTCs are not output.

  5. CHECK FOR DTC (PARKING ASSIST MONITOR SYSTEM)*


    1. Check for DTCs and note any codes that are output.

      Click here

    2. Clear the DTCs.

      Click here

    3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

      Note

      The navigation ECU sub-assembly outputs DTCs for the following systems. When DTCs other than those in Diagnostic Trouble Code Chart for the parking assist monitor system are output, refer to Diagnostic Trouble Code Chart for the relevant systems.

      Result
      Proceed to
      No DTCs are output.
      DTCs for parking assist monitor system are output.
      DTCs for navigation system are output.

    DTCs for parking assist monitor system are output.

    GO TO DIAGNOSTIC TROUBLE CODE CHART Click here

    DTCs for navigation system are output.

    GO TO NAVIGATION SYSTEM Click here

    No DTCs are output.

  6. PERFORM SYMPTOMS TABLE


    1. Refer to the Problem Symptoms Table.

      Click here

      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table
      Fault is listed in Problem Symptoms Table

    Fault is listed in Problem Symptoms Table

    GO TO STEP 8 Click here

    Fault is not listed in Problem Symptoms Table

  7. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Diagnosis System.

      Click here

    2. Terminals of ECU.

      Click here

    3. Data List / Active Test.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  8. ADJUST, REPAIR OR REPLACE

    Result
    Proceed to
    NEXT

    NEXT

  9. CONFIRMATION TEST

    Result
    Proceed to
    NEXT

    NEXT

    END