PARKING ASSIST MONITOR SYSTEM DIAGNOSIS SYSTEM

Select "Function Check/Setting" on the "Service Menu" screen to display the "Function Check/Setting I" screen.

Select "Vehicle Signal" on the "Function Check/Setting I" screen.

Vehicle Signal Check Mode

1. When the "Vehicle Signal Check Mode" screen is displayed, check the item displayed for "REV".

   Tech Tips

   
   

   • Only conditions having inputs are displayed.

   • This screen displays vehicle signals input to the navigation ECU sub-assembly.

Start diagnostic mode Click here.

1. Select "Function Check/Setting" on the "Service Menu" screen to display the "Function Check/Setting I" screen.

2. 

   Select "Camera Setting" on the "Function Check/Setting I" screen.

3. 

   Select "Next" on the "Car Information Check" screen.

   Tech Tips

   After "Next" is selected, the screen transitions differ depending on whether initialization of the parking assist monitor system was performed after the navigation ECU sub-assembly was replaced.

   Parking Assist Monitor System Initialization	Screen Transition
   Not performed	Car Signal Check screen
   Performed	Mode Setting screen

4. 

   When the screen changes to the "Mode Setting" screen, select "Back Camera Setting" to display the "Car Signal Check" screen.

   Tech Tips

   To select a grayed out item, select and hold the item for 2 seconds or more.

Car Signal Check

1. On the "Car Signal Check" screen, it is possible to inspect the state of signals and check the settings.

   Item	Inspection Detail	Note
   BCTY	Back door courtesy switch signal input	When "CHK" (red) is displayed, selecting "Next" will not change to the next screen.

   Tech Tips

   
   

   • When "CHK" (red) is displayed, perform inspections based on the result of the following inspections.

   
   

   • If performing the adjustment after proceeding to the next screen, confirm that all items display "OK" (blue) before selecting "Next".