TELEMATICS SYSTEM, Diagnostic DTC:B15C4

DTC Code DTC Name
B15C4 SRS Communication Error

DESCRIPTION

If the telematics transceiver detects an error in communication between itself and the airbag sensor assembly as a result of a self check, this DTC will be stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
B15C4 SRS Communication Error The telematics transceiver detects an error in signals from the airbag sensor assembly when ignition switch is ON.

  • Telematics transceiver

  • Airbag sensor assembly

  • Wire harness or connector

  • Airbag system

WIRING DIAGRAM

A01V7U7E04
*1 Airbag Sensor Assembly
*2 Telematics Transceiver

CAUTION / NOTICE / HINT

Note


  • Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System.

    Click here

  • This vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.

    Click here

PROCEDURE


  1. CHECK DTC (AIRBAG SYSTEM)


    1. Turn the ignition switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the ignition switch to ON and wait for 20 seconds.

    4. Turn the GTS on.

    5. Check if airbag system DTCs are output.

      Click here


      Body Electrical > SRS Airbag > Trouble Codes
      Result
      Result Proceed to
      DTCs are not output A
      DTCs are output B

    B

    GO TO AIRBAG SYSTEM Click here

    A

  2. CHECK TELEMATICS TRANSCEIVER


    1. A01V7QOC19
      *a

      Component with harness connected

      (Telematics Transceiver)
      *b Waveform

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      24 (GSW) - Body ground Ignition switch ON Pulse generation (Refer to waveform)
      Reference Waveform
      Item Condition
      Tester connection M38-24 (GSW) - Body ground
      Tool setting 5.0 V/DIV., 20 ms/DIV.
      Vehicle condition Ignition switch ON
      Result
      Proceed to
      OK
      NG

    NG

    CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - AIRBAG SENSOR ASSEMBLY) Click here

    OK

  3. REPLACE TELEMATICS TRANSCEIVER


    1. Replace the telematics transceiver with a new one.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

    PERFORM REGISTRATION Click here

  4. CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - AIRBAG SENSOR ASSEMBLY)


    1. Disconnect the M38 telematics transceiver connector.

    2. Disconnect the G92 airbag sensor assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      M38-24 (GSW) - G92-24 (GSW3) Always Below 1 Ω
      M38-24 (GSW) or G92-24 (GSW3) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE AIRBAG SENSOR ASSEMBLY Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR