NAVIGATION ECU REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY (for Radio and Display Type)

    Click here

  4. REMOVE WIRE HARNESS

    A01V6PO

    1. Disconnect each connector and remove the wire harness.

  5. REMOVE NO. 1 RADIO BRACKET


    1. A01VA0D

      except 7 inch Type


      1. Remove the 5 screws and No. 1 radio bracket.

    2. A01V9CX

      for 7 inch Type


      1. Remove the 5 screws and No. 1 radio bracket.

  6. REMOVE NO. 2 RADIO BRACKET


    1. A01VAUD

      except 7 inch Type


      1. Remove the 5 screws and No. 1 radio bracket.

    2. A01V8U1

      for 7 inch Type


      1. Remove the 5 screws and No. 1 radio bracket.

  7. REMOVE NAVIGATION ECU


    1. A01V931

      Detach the 2 guides and remove the navigation ECU as shown in the illustration.

    2. A01V71S

      Detach the clamp.

    3. Disconnect the connector and remove the antenna cord.