NAVIGATION RECEIVER REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL

    Click here

  4. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

    Click here

  5. REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

    Click here

  6. REMOVE TELLTALE LIGHT ASSEMBLY

    Click here

  7. REMOVE NAVIGATION RECEIVER ASSEMBLY


    1. A01V7XX

      Remove the 4 bolts.

    2. Detach the 4 clips and remove the navigation receiver assembly with bracket.

    3. Disconnect each connector.

  8. REMOVE NO. 1 RADIO BRACKET


    1. A01V97A

      Remove the 3 screws and No. 1 radio bracket.

  9. REMOVE NO. 2 RADIO BRACKET

    A01V72F

    1. Remove the 3 screws and No. 2 radio bracket.