RADIO ANTENNA CORD(for Roof Side) INSTALLATION

PROCEDURE


  1. INSTALL NO. 3 ANTENNA CORD SUB-ASSEMBLY


    1. Attach the 3 clamps to install the No. 3 antenna cord sub-assembly.

    2. Install the bolt.

      Torque:
      4.5 N*m  { 46 kgf*cm, 40 in.*lbf }

    3. Connect each connector.

  2. INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY


    1. Apply new double-sided tape as shown in the illustration.

      A01KARHC02
      *A w/o Sliding Roof *B w/ Sliding Roof
      *1 One-sided Tape - -
      *a Double-sided Tape Application Marking *b Positioning Tape
      *c Surplus Cord Area - -

    2. Align the positioning tape for the front side of the antenna cord with the edge of the double-sided tape application marking and attach it as shown in the illustration.

    3. Align the positioning tape for the rear side of the antenna cord with the edge of the double-sided tape application marking and attach it as shown in the illustration.

      Tech Tips

      Place any extra antenna cord length in the surplus cord area shown in the illustration.

    4. Secure both ends of the antenna cord using one-sided tape as shown in the illustration.

  3. INSTALL ROOF HEADLINING ASSEMBLY

    Click here

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  5. CHECK SRS WARNING LIGHT

    Click here