RADIO ANTENNA CORD(for Roof Side) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE ROOF HEADLINING ASSEMBLY

    Click here

  4. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY


    1. Apply masking tape to the No. 2 antenna cord sub-assembly.

      Tech Tips

      Apply the masking tape so that the edges of the masking tape and roof headlining are aligned as shown in the illustration.

    2. Remove the antenna cord from the roof headlining.

      A01V8AAC01
      *A w/o Sliding Roof *B w/ Sliding Roof

    3. Remove the double-sided tape from the roof headlining.

  5. REMOVE NO. 3 ANTENNA CORD SUB-ASSEMBLY


    1. Disconnect each connector.

    2. Remove the bolt.

      A01V8F6

    3. Detach the 3 clamps and remove the No. 3 antenna cord sub-assembly.