STEERING COLUMN ASSEMBLY REASSEMBLY

CAUTION / NOTICE / HINT

Note


  • When using a vise, place aluminum plates between the part and vise.

  • When using a vise, do not overtighten it.

PROCEDURE


  1. INSTALL POWER STEERING MOTOR ASSEMBLY


    1. Apply grease to the spline part of the electric power steering column sub-assembly.

    2. Install a new O-ring to the power steering motor assembly.

    3. A01V6R9

      Install the power steering motor assembly with the new 2 bolts.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

    4. Place new heat resistant tape.

      Note

      As heat from the power steering motor assembly may generate smoke, use heat resistant tape (resistant to 100°C (212°F) or higher).

  2. INSTALL POWER STEERING ECU ASSEMBLY

    Click here

  3. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Entry and Start System)


    1. A01V927

      Turn the ignition switch to ACC.

    2. Install the ignition switch lock cylinder assembly into the upper steering column bracket assembly.

    3. Make sure that the ignition switch lock cylinder assembly is securely fixed onto the ignition switch lock cylinder assembly.

  4. INSTALL UNLOCK WARNING SWITCH ASSEMBLY (w/o Entry and Start System)


    1. A01V7EV

      Attach the 2 claws to install the unlock warning switch assembly onto the upper steering column bracket assembly.

      Tech Tips

      Slide the unlock warning switch assembly in the direction shown by the arrow in the illustration to install it.

  5. INSTALL KEY INTERLOCK SOLENOID (for Automatic Transaxle and CVT)


    1. A01V9WU

      Install the key interlock solenoid onto the upper steering column bracket assembly with the screw.

  6. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY (w/o Entry and Start System)

    Click here

  7. INSTALL TRANSPONDER KEY COIL (w/o Entry and Start System)

    Click here

  8. INSTALL STEERING LOCK ACTUATOR ASSEMBLY (w/ Entry and Start System)

    Tech Tips

    When replacing the steering lock actuator assembly, refer to the Service Bulletin.


    1. Temporarily install the steering lock actuator assembly with 2 new tapered-head bolts.

      Note

      Be sure to use 2 new tapered-head bolts.

    2. A01V6WHC01

      Tighten the 2 tapered-head bolts until the bolt head breaks off.

      Tech Tips

      Tighten the nuts in the order shown in the illustration.

  9. INSTALL STEERING LOCK ACTUATOR ASSEMBLY (w/o Entry and Start System)

    Tech Tips

    Refer to "INSTALL STEERING LOCK ACTUATOR ASSEMBLY (w/ Entry and Start System)"