STEERING COLUMN ASSEMBLY DISASSEMBLY

CAUTION / NOTICE / HINT

Note


  • When using a vise, place aluminum plates between the part and vise.

  • When using a vise, do not overtighten it.

PROCEDURE


  1. REMOVE STEERING LOCK ACTUATOR ASSEMBLY (w/ Entry and Start System)


    1. Secure the steering column assembly in a vise.

    2. Using a center punch, mark the center of the tapered-head bolts.

    3. Using a 3 to 4 mm (0.12 to 0.16 in.) diameter drill bit, drill a hole in the tapered-head bolt.

    4. A01V999C01
      *1 Screw Extractor

      Using a screw extractor, remove the 2 tapered-head bolts, and then remove the steering lock actuator assembly from the steering column assembly.

  2. REMOVE STEERING LOCK ACTUATOR ASSEMBLY (w/o Entry and Start System)

    Tech Tips

    Refer to "REMOVE STEERING LOCK ACTUATOR ASSEMBLY (w/ Entry and Start System)"

  3. REMOVE TRANSPONDER KEY COIL (w/o Entry and Start System)

    Click here

  4. REMOVE IGNITION OR STARTER SWITCH ASSEMBLY (w/o Entry and Start System)

    Click here

  5. REMOVE KEY INTERLOCK SOLENOID (for Automatic Transaxle and CVT)


    1. A01V9WU

      Remove the screw and key lock solenoid from the upper steering column bracket assembly.

  6. REMOVE UNLOCK WARNING SWITCH ASSEMBLY (w/o Entry and Start System)


    1. A01V877

      Insert the key.

    2. Remove the unlock warning switch assembly by releasing the 2 claws.

      Tech Tips

      Slide the unlock warning switch assembly in the direction shown by the arrow in the illustration to remove it.

  7. REMOVE IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Entry and Start System)


    1. Turn the ignition switch to ACC.

    2. A01V9GZC01
      *1 Claw
      *2 Stopper
      *a Push
      *b Pull

      Insert the tip of a screwdriver into the hole in the upper steering column bracket assembly as shown in the illustration, and pull the ignition switch lock cylinder assembly out until its claw comes into contact with the stopper of the upper steering column bracket assembly.

      Note

      Pull the ignition switch lock cylinder assembly out until the claw comes into contact with the stopper of the upper steering column bracket assembly. Otherwise, the following procedure cannot be conducted properly.

    3. A01V9TKC01
      *1 Claw
      *2 Stopper
      *a Claw detached
      *b Driver Insertion Hole
      *c Tilt
      *d Pull out

      Insert the tip of a screwdriver into the hole in the steering column bracket and tilt it downward as shown in the illustration to detach the claw on the ignition switch lock cylinder assembly. Then pull out the ignition switch lock cylinder assembly.

  8. REMOVE POWER STEERING ECU ASSEMBLY

    Click here

  9. REMOVE POWER STEERING MOTOR ASSEMBLY


    1. A01V6R9

      Remove the 2 bolts and power steering motor assembly.

    2. Remove the O-ring from the power steering motor assembly.