POWER STEERING ECU INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.


  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL POWER STEERING ECU ASSEMBLY


    1. Install the power steering ECU assembly with 2 new bolts.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

    2. Install 3 new terminal bolts.

      Torque:
      3.2 N*m  { 33 kgf*cm, 28 in.*lbf }

    3. Connect the 2 connectors and 2 harness clamps, and install a new ECU wire sub-assembly to the power steering ECU.

    4. Install 2 new power steering ECU protectors to the power steering ECU assembly.

  2. INSTALL ELECTRIC POWER STEERING COLUMN SUB-ASSEMBLY

    Click here

  3. INSTALL UPPER INSTRUMENT PANEL

    Click here

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. CHECK SRS WARNING LIGHT

    w/ Occupant Classification System: Click here

    w/o Occupant Classification System: Click here

  6. ASSIST MAP WRITING

    Click here