BRAKE PEDAL REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. PRECAUTION

   Note

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

3. REMOVE UPPER INSTRUMENT PANEL

   Click here

4. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)

   Click here

5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Driver Side Knee Airbag)

   Click here

6. DISCONNECT CONNECTORS

   
   

   1. Disconnect the stop light switch connector.

   2. Detach the 2 clamps from the brake pedal support.

7. REMOVE STOP LIGHT SWITCH ASSEMBLY

   Click here

8. REMOVE BRAKE PEDAL RETURN SPRING

   
   

   1. Remove the brake pedal return spring from the brake pedal support.

9. REMOVE PUSH ROD PIN

   
   

   1. Remove the clip from the push rod pin.

   2. Remove the push rod pin from the push rod clevis.

10. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

    
    

    1. 

       *1	Instrument Panel Reinforcement
       *2	Brake Pedal Support

       Remove the brake pedal support reinforcement set bolt.

    2. 

       Remove the 4 nuts and brake pedal support assembly.