RELAY ON-VEHICLE INSPECTION

PROCEDURE


  1. CHECK STOP LIGHT CONTROL RELAY (STOP LP)


    1. Remove the stop light control relay (STOP LP) from the engine room relay block.

    2. A00YR55N01

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 4 Battery positive (+) voltage not applied to terminal 1 and battery negative (-) voltage applied to terminal 2 Below 1 Ω
      Battery positive (+) voltage applied to terminal 1 and battery negative (-) voltage applied to terminal 2 10 kΩ or higher
      3 - 5 Battery positive (+) voltage not applied to terminal 1 and battery negative (-) voltage applied to terminal 2 10 kΩ or higher
      Battery positive (+) voltage applied to terminal 1 and battery negative (-) voltage applied to terminal 2 Below 1 Ω

      If the result is not as specified, replace the relay.

    3. Install the stop light control relay (STOP LP).