DOWNHILL ASSIST CONTROL SWITCH INSPECTION

PROCEDURE


  1. CHECK DOWNHILL ASSIST CONTROL SWITCH


    1. A00YU04C02
      *a Component without harness connected (Downhill Assist Control Switch)
      *b Pushed
      *c Not pushed

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      1 - 4 Not pushed 10 kΩ or higher
      1 - 4 Pushed Below 25 Ω

      If the result is not as specified, replace the switch.

    2. Check the illumination operation.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → Terminal 3

      Battery negative (-) → Terminal 2

      		 Bulb illuminates

      If the result is not as specified, replace the switch.