STEERING ANGLE SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR


    1. Install the spiral cable with steering angle sensor.



      Note


      • Do not replace the spiral cable with the battery connected and the ignition switch ON.

      • Do not rotate the spiral cable with the battery connected and the ignition switch ON.

      • w/ Vehicle Stability Control System:

        Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.

      • Do not remove the steering angle sensor from the spiral cable.

  2. INSTALL STEERING COLUMN COVER

    Click here

  3. INSTALL STEERING WHEEL ASSEMBLY

    Click here

  4. INSTALL STEERING PAD ASSEMBLY

    Click here

  5. INSPECT STEERING WHEEL CENTER POINT

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. INSPECT STEERING PAD ASSEMBLY

    Click here

  8. CHECK SRS WARNING LIGHT